Keeping your Apex 7 wrist rest clean is important for both hygiene and performance. A dirty wrist rest can harbor bacteria, dirt, oil, and other contaminants that can not only be unhealthy, but also make the surface feel greasy and impact glide. Thankfully, cleaning the Apex 7 wrist rest is straightforward. With routine gentle cleaning and deeper periodic cleaning, you can keep your wrist rest fresh.
Regular Cleaning
For routine cleaning, you’ll want to wipe down your Apex 7 wrist rest every few days to remove built up grime and oils. Here are some tips:
- Use a soft microfiber cloth dampened with warm water. Avoid using paper towels or other rough materials that could scratch the surface.
- If water alone doesn’t remove dirt or oils, use a mild soap diluted in the water. Dish soap or hand soap works well. Avoid harsh cleaners.
- Gently wipe the surface using a back and forth motion. Don’t press too hard or you may push grime into the material.
- You can use a small amount of isopropyl alcohol on tough spots. This helps dissolve oils. Just dampen your cloth, don’t saturate it.
- Wipe the wrist rest dry before using to prevent liquids from getting inside.
With regular light cleaning, you can maintain a nice feel and remove any grimy buildup.
Deep Cleaning
For a more thorough cleaning, you’ll want to deep clean your Apex 7 wrist rest every month or two. This helps sanitize the surface and remove any deeply ingrained gunk.
Here are some tips for deep cleaning:
- Mix a solution of warm water and a small amount of mild dish soap or hand soap.
- Using a soft cloth, gently scrub every inch of the wrist rest surface with your cleaning solution.
- If needed, use a scrub brush with soft plastic bristles to help agitate and lift dirt from crevices.
- Hold the wrist rest under running warm water and rinse thoroughly to remove all soap residue.
- Pat dry with a clean soft towel.
- Allow to fully air dry before using.
The thorough scrubbing helps release stubborn dirt, skin oils, and grime that may build up over time. Just don’t use anything too abrasive during cleaning.
Cleaning Tips
Here are some additional tips for successful cleaning of your Apex 7 wrist rest:
- Avoid harsh cleaners or bleach that could degrade materials or coatings.
- Don’t submerge or soak the wrist rest as moisture can damage internals.
- Always wipe dry after cleaning and before using.
- Clean around buttons and seams using cotton swabs.
- Consider using wrist rest covers to protect the surface between cleanings.
Cleaning Products
You likely already have everything you need, but here are some recommended cleaning products:
Product | Use |
---|---|
Distilled water | Dilute soap solutions |
Dish soap | Dissolve grease and oils |
Isopropyl alcohol | Sanitize and remove stubborn spots |
Microfiber cloth | Gentle cleaning |
Scrub brush | Agitate grime in crevices |
Avoid harsh chemicals or anything that could scratch plastic or rubberized surfaces. Stay gentle!
When to Replace
With proper routine cleaning, your Apex 7 wrist rest should last for years before needing replacement. Here are some signs it may be time for a new wrist rest:
- The surface is cracked, warped, or peeling.
- There are deep stains that can’t be removed.
- The foam interior has collapsed or hardened.
- You notice fraying around the edges.
- The surface feels very slippery or uneven.
If you notice any of these issues, the wrist rest is reaching the end of its lifespan. Replacement Apex 7 wrist rests are available from SteelSeries.
Conclusion
Keeping your Apex 7 wrist rest clean with regular gentle cleaning and periodic deep cleaning will remove grime and oils to keep it feeling fresh. Just be sure to use only soft cloths and mild soap and water. Avoid harsh chemicals or anything abrasive. With proper care, your wrist rest should last for years before needing replacement. Keeping it clean promotes good hygiene while also maintaining proper glide and comfort.